J. Ocean Eng. Technol. Search

CLOSE


J. Ocean Eng. Technol. > Volume 40(5); 2026 > Article
J. Ocean Eng. Technol. 2026;40(5):549-564.    
Available online October 7, 2026.
DOI: https://doi.org/10.26748/KSOE.2026.041   

Geometry-Driven Inertia Variation in Submarine Ballast Tanks during Blowing and Limitations of Simplified Models
Jae Sang Jung1  , Sung wook Lee2 
1Principal Engineer, Korea Research Institute of Ship and Ocean Engineering (KRISO), Busan, Republic of Korea
2Professor, Korea Maritime and Ocean University, Busan, Republic of Korea
Corresponding author: Sung wook Lee, Tel: +82-51-410-4303, swlee@kmou.ac.kr
Received July 22, 2026   Revised August 13, 2026   Accepted September 3, 2026
© 2026 The Korean Society of Ocean Engineers     Open access / Under a Creative Commons License
Keywords: Ballast tanks, Blowing operation, Emergency rising of submarines, Moments of inertia, Voxelization
Abstract
Predicting submarine motion during emergency rising requires accurate estimation of the moments of inertia during ballast tank blowing, yet prior studies approximate tanks as simple cubes or cylinders that may not reflect real mass distributions. This study develops a voxelization framework that computes moments of inertia directly from computer-aided design geometry without simplification. Three tanks of identical volume and mass (cube, cylinder, and U-shaped) were analyzed under stepwise blowing (100–40% mass) and pitch rotation (0–30 degrees), and the resulting inertia was coupled with the hull inertia. At full mass, the U-shaped tank showed 113.3% and 50.0% higher roll-axis inertia (Ixx) than the cube and cylinder, respectively. Ixx decreased by 55–57% as mass fell to 40%, with a further 9–11% reduction under a 30-degree pitch rotation for the cylinder and U-shaped tanks but none for the cube. When coupled with the hull inertia, the geometry-induced difference in total inertia remained within 3.3% for the roll axis and below 0.1% for the pitch and yaw axes, for which the position inertia term dominates. Tank geometry therefore strongly affects tank self-inertia but influences overall submarine inertia only in roll motion, governed by Ixx. The proposed approach offers an efficient tool for evaluating simplified ballast tank models.
TOOLS
Share :
Facebook Twitter Linked In Google+ Line it
METRICS Graph View
  • 0 Crossref
  •   Scopus
  • 572 View
  • 17 Download


ABOUT
BROWSE ARTICLES
ARTICLE CATEGORY

Browse all articles >

PUBLICATION ETHICS
FOR CONTRIBUTORS
Editorial Office
President Office BD Rm. 1302, 13 Jungang-daero 180beon-gil, Dong-gu, Busan 48821, Republic of Korea
Tel: +82-51-759-0656    Fax: +82-51-759-0656    E-mail: ksoehj@ksoe.or.kr                

Copyright © 2026 by The Korean Society of Ocean Engineers.

Developed in M2PI

Close layer
prev next