Corrigendum to: Dynamic Power Cable Layout Design for 15 MW Floating Offshore Wind Turbines: Part 1 - Configuration Analysis and Optimization

Article information

J. Ocean Eng. Technol. 2025;39(4):487-488
Publication date (electronic) : 2025 August 25
doi : https://doi.org/10.26748/KSOE.2025.014c1
1Master's degree candidate, Department of Naval Architecture and Ocean Engineering, Inha University, Incheon, Korea
2Team leader, Ocean Power System Research Team, Taihan Cable & Solution, Seoul, Korea
3Professor, Department of Naval Architecture and Ocean Engineering, Inha University, Incheon, Korea
Corresponding author Joonmo Choung: +82-32-860-7346, heroeswise2@gmail.com
Received 2025 August 13; Revised 2025 August 13; Accepted 2025 August 22.

Corrogendum to: Journal of Ocean Engineering and Technolog, 39(3), 317–326, June, 2025

https://doi.org/10.26748/KSOE.2025.014

The authors would like to correct values in Fig. 7(b) and Table 4. The modified figure and table are as shown below.

Fig. 7

Comparison of optimal cases

Section lengths of optimal cases

In addition, in the original article, page 320, Section 2.3 Numerical modeling, the suspended length value should be corrected from 132 m to 140 m in the following sentences:

  • (1) “The total buoyancy of the DBMs was set to 140% and 230% of the displacement corresponding to a length of 140 m – the suspended length without DBMs.”

  • (2) “When DBMs were not installed on the cable, the suspended length was 140 m, and the total buoyancy of the DBMs was assumed to be 140% and 230% of the displaced volume corresponding to the suspended length.”

The authors would like to apologise for any inconvenience caused.

Article information Continued

Fig. 7

Comparison of optimal cases

Table 4

Section lengths of optimal cases

Section Unit Buoyancy 140% Buoyancy 230%
L1 m 140 140
L2 m 49 105
L3 m 61 83
L4 m 450 372