J. Ocean Eng. Technol. Search

CLOSE


J. Ocean Eng. Technol. 1994;8(1):131-143.    

A Study on the Characteristics of CNC Deep Hole Machining for Marine Part Materias with the Single Tube System BTA Tools
싱글튜브시스템 BTA공구에 의한 박용부품소재의 CNC 심공가공 특성에 관한 연구
전태옥,전언찬,장성규,심성보
동아대학교,동아대학교,한국ABSystem,부산공업대학교
© 1994 The Korean Society of Ocean Engineers     Open access / Under a Creative Commons License
Keywords: Lobe, Chip Curling, Burnishing, Roundness, Guide pad
핵심용어: 다각형의 각부, 침컬링, 비어니싱, 진원도, 안내패드
Abstract
The BTA(boring and trepanning association) deep hole machining has an increasing demands because of its wide applications and its good productivity. The main feature of the BTA tools is that the tool cutting edges are unsymmetrically located on the boring head. This provides a stabilizing cutting force resultant necessary for self guidance of the boring head. The BTA tools are capable of machining for having a large length to diameter ratio in single pass. A study of the accuracy and surface finish of holes produced would reveal quite useful information regarding the process. This study deals with the experimental results obtained during BTA machining on SM55C, SM45C steel under differnt machining conditions.


ABOUT
BROWSE ARTICLES
ARTICLE CATEGORY

Browse all articles >

PUBLICATION ETHICS
FOR CONTRIBUTORS
Editorial Office
President Office BD Rm. 1302, 13 Jungang-daero 180beon-gil, Dong-gu, Busan 48821, Republic of Korea
Tel: +82-51-759-0656    Fax: +82-51-759-0656    E-mail: ksoehj@ksoe.or.kr                

Copyright © 2024 by The Korean Society of Ocean Engineers.

Developed in M2PI

Close layer
prev next